2016 Masaba 10x16

Masaba Portable Belt Feeder w/ adjustable height discharge belt
10’ x 16’ Hopper (18 to 20yd hopper) & Chassis

Main Frame - constructed of wide flange beam with (2) Freuhalf style Crank down leveling jacks & chord holder

Tow Hook – Tow hook for in pit moving via loader.

Tandem Axle – with (8) 11:00 x 22.5 bias ply tires, air brakes, mud flaps, brake & directional signals

Hopper –Tapered self relieving hopper design. 10’ wide x 16’ long constructed of 1/4" steel plate with baffle and adjustable rubber flashing. Hopper lined with 3/8” AR400.

Grizzly Section – Grizzly Bars – ¾”x 4” bar stock capped Grizzly bars held “loose” so as to allow better clearing of rock when dumped. Nominal 6” spacing.

Hydraulic Package – 15 Hp electric motor, pump, cylinders, reservoir, valve body, plumbing, & Remote

Guarding – Appropriate guarding supplied. We do not warrant that our guards will meet all local codes. It is the responsibility of the end user to have them checked by a local inspector.

Guard –steel guard to protect under carriage

42” x 20’ Belt Feeder

Drive – Head drive with jackshaft

Gear reducer – Dodge TA #7 with four groove sheave & QD bushing, no backstop

Motor – 50 Hp, 1800 rpm, tefc, 460v, 3ph, 60 Hz

Belt speed – 0 - 100 FPM (with appropriate sheaves)

Drive pulley – 18” diameter rubber lagged drum pulley

Drive shaft & bearings – 4 7/16” shaft with Dodge SCM bearings

Tail pulley – 16” diameter self cleaning wing pulley

Tail shaft & bearings – 3 15/16” shaft with Dodge SCM bearings

Belt Wiper

Idlers – Superior LS536 1 15/16” live shaft idlers on 9” spacing

Idler Bearings – (2) Dodge 1 15/16” Scm pillow block bearings per idler

VARIABLE SPEED

48” Adjustable Height Discharge Conveyor (17.5’ discharge height)

Drive – Head drive

Gear reducer – Dodge #7 with four groove sheave & QD bushing, with backstop

Motor – 40 Hp, 1800 rpm, tefc, 460v, 3ph, 60 Hz

V-belt drive – With drive guard

Belt speed – 350 FPM

Drive pulley – 20” diameter rubber lagged drum pulley

Drive shaft & bearings – 4 7/16” shaft with Dodge SCM bearings

Tail pulley – 18” diameter self cleaning wing pulley

Tail shaft & bearings – 3 15/16” shaft with Dodge SCM bearings

Belting – 48” 3 ply 1/4” x 1/16” conveyor belt

Belt scraper

Impact Idlers – Superior Cema C, 5” diameter rubber impact idlers in loading area

Adjustable height support – Hydraulic raise / lower with manual pin lock


Switchgear - Plant mounted in NEMA enclosure with Variable Frequency Drive for belt feeder, start stop for discharge conveyor, start stop for hydraulic power unit, remote dump for grizzly, e-stop & disconnect.